In this manual we will explain the connection of wires and the connection with a ZigBee Light
These devices works with many ZigBee Light Link Gateways* like , Amazon Echo Plus.
1.Turn off the Power.
2.Plug in the bulb.
3.Now you can connect it with the gateway.
Connection with Gateway:
1.Connect the LED product to the controller see section “Installation”.
2.Start the device searching on the ZigBee Light Link Gateway, it could take some time.
If the Gateway does not find the device, plug power off/on or make a reset.
3.The Gateway found your device and you can assign it to the different
4.Now you can use the device.
1.Switch on your device.
2.Now switch off and on within 2 seconds.
3.Repeat off/on four times.
4.Reset is done when the device is switched on in the fifth time and the light stays on after
blinking 4 times
Voltage: AC96-265V / 50-60Hz
Luminous Flux: 500LM
Luminous Efficiency: 83LM/W
Beam Angle: 220°
Material: Aluminum+PC Cover